This article will guide you on how to set up the Linksys EA9350 v3.

 

Before you begin:

 

• The Linksys EA9350 v3 now supports Automatic Configuration Server (ACS) setup with the latest firmware. Once the parent detects an internet connection, it will automatically begin setting up the router. There's no need to do anything. Do not use the Linksys app to set up the router.
• Parent node - This is the Linksys router connected to your ISP equipment.
• Child node - This is another Linksys Velop Mesh node such as another Linksys EA9350 v3 used to extend your WiFi. Note that the Linksys EA9350 v1 and v2 are not supported.

1. Gather all your equipment in the same area as your modem. After setup, you can relocate your child nodes. 

 

2. Remove any existing routers.

 

a. I have a modem with an existing router.

 

• • Disconnect your existing router.
  • Power cycle your modem.
  • Wait until your modem has rebooted and go to the next step.

 

b. I have a WiFi router and modem in one device or I do not have any existing routers in my home.

 

• • Go to the next step.

 

3. Connect the Linksys router to your modem using an ethernet cable from the yellow Internet port on the router to your modem. Make sure all four antennas are pointing up.

 

 

4. Power ON the Linksys router. The power switch is on the back of the router. Wait until the light turns solid purple which indicates it is ready for setup.

 

 

5. After a few minutes, the light will begin blinking white indicating the router has detected an internet connection and it’s going through automatic setup. Wait until the setup is complete.

 

The light on the parent router will turn from solid purple to solid blue. A solid blue light indicates the router is online and ready to use.

 

 

 
If the light does not turn solid blue, perform either of the following:

 

• Red light - If the light turns red, hold down the reset button for about 20 seconds. Then, wait until the light turns solid purple.
• Purple light - A solid purple light indicates the router is ready for setup. If the router is on the latest firmware, it should automatically start detecting the internet connection from your modem. However, if the light does not change, it’s possible the router may be on an older firmware and does not support automatic setup yet. You can set it up using the Linksys app or a computer.

 

6. You can now connect your wireless devices to your WiFi. The WiFi credentials are located on the product label.

 

 

Find out more:

 

How to log in to the Linksys app dashboard
How to add a child node using the web interface
Adding a child node to your existing Linksys Velop Intelligent Mesh WiFi system
Understanding the light behavior of your Linksys Mesh WiFi system