
HARDWARE INFORMATION
The Linksys Cognitive Mesh technology is an advanced networking technology designed to optimize and enhance the performance of mesh WiFi systems. It aims to deliver a seamless, high-performance WiFi experience by intelligently managing the network in real-time.
Wi-Fi 7, also known as 802.11be, is designed to support the growing demand for high-speed, low-latency wireless connectivity, particularly in environments with many connected devices and high data consumption.
It has the following features:
- Linksys Velop Pro 7 10G
- Linksys Cognitive Mesh technology
- Tri-band Wi-Fi 7 BE11000
- 2x2x2 Spatial Streams
- Parental Controls
- 1.5 GHz quad-core Qualcomm® processor
- Next-generation Orthogonal Frequency-Division Multiple Access (OFDMA) technology
- Supports 2.4 GHz, 5 GHz, and 6 GHz radio bands (Wi-Fi 7 is supported on 5 GHz and 6 GHz)
The serial and model numbers are printed on the router's product label.
The warranty period is dependent on the country of purchase.
The node has one status indicator light that gives information about its operation.
No, this is not supported.
It is recommended to keep the same Mesh technology in a network. If you have Linksys Intelligent Mesh products, make sure to keep the Linksys LN1400YZ as the parent router.
It has five ethernet ports:
- One 10 Gbps internet WAN port
- Four ethernet LAN ports at 2.5 Gbps
The Night mode feature, when enabled, turns OFF the light on the Linksys LN1400YZ nodes from 8 PM to 8 AM.
The MLO feature is currently in the beta phase.
SETUP AND INSTALLATION
Learn how to set up the router by following these steps.
Some Yayzi subscribers’ equipment may not support the required VLAN configuration which is enabled by default on the router. You can either contact your ISP to confirm, or you can try to disable the VLAN configuration on the Linksys router, and then try setting it up again.
Note that whenever the router is reset, this VLAN will be enabled again, therefore you will need to disable it again. Learn how to disable the VLAN configuration.
Below are the requirements for setting up the Linksys LN1400YZ.
- An active internet connection with Yayzi ISP
- A mobile device (iOS or Android™) or a computer to manage your router’s settings
To add a child node, follow these steps. We offer various methods. You can either add another Linksys LN1400YZ as a child node when you set up the parent router for the first time or if your parent router is already set up, you can add a child node using the Pair button which is the easiest method.
- The default IP address is 192.168.1.1.
- The default WiFi name is Linksysxxxxx, where xxxxx represents the last five digits of its serial number.
- Each node has a unique pre-assigned WiFi password located at the bottom of the node.
- The default Guest WiFi name is Linksysxxxxx-guest where xxxxx represents the last five digits of the node’s serial number.
To configure the Guest Network, follow these steps. You will need to use a desktop computer.
SECURITY AND PRIVACY
The Linksys LN1400YZ supports the following settings:
- WPA2™/WPA3™ Mixed Personal
- WPA3 Personal
- WPA2 Personal
- Enhanced Open Only
- Open and Enhanced Open
- Open
ADVANCED TROUBLESHOOTING
To set up your child nodes, make sure that they are near the parent router (node connected to your modem), within 10 ft of distance. If possible, put them in the same room as the parent rouer. Once they have been added, you can move them to other locations as needed.
To reset the router, follow these steps.